Let us talk about another quite common yet unignorable issue, vibration in gas pedal while driving. I bet many of you have already faced or at least faced this issue once in life. Even if you have not, it is important to know. Stay tuned to gain some knowledge about this issue, its causes, and of course, fixes. So let us begin.
Why Do I Feel Vibration In My Gas Pedal?
Although it is a tough job to troubleshoot vibrations in a vehicle, by doing a little hard work can help us greatly. There are a few prominent reasons for vibration such as loose bolts and bearings, unbalanced wheel structure, vibration while applying brakes, etc. In this article, our main focus will be on the third one i.e. noise and vibration in gas pedal. A few causes are listed below:
1. Out Of Balance Internals
Any vibration occurs due to something rotating that is out of balance. So the possibility is any internal rotating part of the gas pedal is displaced.
2. Broken Wrapper Rotors
Wrapper rotors are the stuff your brake pads press. As a result, your vehicle stops down or retards. When these get damaged, the vehicle is bound to malfunction.
3. Exhaust Leak
Although it will not be much prominent while the vehicle is steady or parked, it can be experienced very well while accelerating. As the pressure with which fumes release from the surface area is quite high and the surface area, on the contrary, is small. It causes noise and vibration in gas pedal and sometimes the whole vehicle too.
4. Faulty Brake System
Since the fault is in the gas pedal, so the whole brake system is responsible. Always have such problems fixed as soon as possible before they worsen or you may have to face terrible consequences.
5. Uneven Brake Discs
Check for uneven and displaced drums or brake discs as they may be the main culprits behind this issue. They may be wrapped or worn out probably after prolonged use.
How To Remove Vibration In Gas Pedals?
After pondering upon the potential causes of vibration in gas pedal, it is now time to figure out how to solve this issue. Below are a few measures one can take for troubleshooting after spotting this issue:
1. Maintain An Ideal Gas Fuel Level
Many people often ignore this fact whereas in a true sense, this measure can solve the majority of your problems. Always maintain a decent level of fuel in your vehicle and it will help you stay away from any fuss.
2. Professional Help
As brakes are the most important part of one’s safety while driving, always make sure to attend a professional before they become too apparent. Never wait to address a vehicle issue as it will only worsen.
3. Check Brake System
As mentioned above, the fault may lie in the brake system. So make sure to get it checked and replaced if needed. Make sure to use good quality replacements to avoid any further misconduct.
4. Replace Discs
Wrapped or worn out brake discs should be prepared with fresh working ones. Buy them online or get them from the nearest market. Alternatively, you may also book an appointment for maintenance at the dealer showroom.
5. Vacuum Seal
Do not forget to check if there is still any vacuum invasion or not. If yes, spot the point of leakage and seal it properly in an air-tight manner.
I know still many questions might be popping up in your mind, so here is a bonus question for you:
Can An Exhaust Leak Cause Vibration?
In simple words, yes! If your vehicle vibrates while driving or accelerating then the most prominent reason is an exhaust leak causing vibration due to a small hole or rupture. It promotes unwanted shaking and vibration. Loud engine rumbling and decreased performance and fuel efficiency can also be spotted. So in case you post any such signs or check engine light is on go to professional help soon.
It is better to repair it before the damage gets out of control. Also never compromise on quality. Now I hope all your queries are solved. If not, just let us know it below in the comment section and we will get back to you soon.